What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
14.06.2025 03:40

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
This one hit behind the barn.
There are three different concepts here that are getting confused.
How might an Indian girl respond to someone saying "I love you"?
What is lightning?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
A fuse is a non-resetable over current circuit protector.
What is after school detention like in your school?
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
but I think this circuit , shows a few more pieces.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Why is the Middle East prone to terrorism?
But it can get overloaded, and no longer works.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
It also is a device that limits the change in current flow.
What did someone say to you that instantly made you realize their life was in danger?
At one ohm, the resistor has a maximum of 1 watt power.
Edit 2024–10.
[old diagram got deleted by accident]
What life lesson did you learn the hard way?
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
but this device (an Inductor) … impedes the rapid changes in the current.
What do you like the most about black people?
He then describes Rainy Season and Lightning.
This is where this question deviates from being a 'generic' question, and becomes more specific.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Why do diabetic people sweat so much?
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
(Dc diagram shown, AC is similar).
Why am I so afraid that gun owners have set traps to kill me outside my house or my car?
a photo is worth a thousand words.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
These are simplified answers to the original question, and does not change anything I wrote above.
so, what happens?
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
There are two important concepts here.
What do you say after "Hi" when chatting?
So, the voltage could go up to 500 volts, and the fuse will not open up.
Upvotes:
These devices are installed between the “hot” and “neutral” and protective ground.
What are some common historical misconceptions?
But… the neutral is now “floating” because of the 1 ohm resistance.
The third is lightning and “how it gets conducted into a home.”
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Why is blood sugar ranging from 70-180 in a day and checked through a glucometer?
What does a fuse do?
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
This is 'the assistant's answer'
This device then solves the entire problem.
At least they know the answer if they wanted it.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
2024–10–14 [Omar Gharbi Omar Gharbi ]
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
He then describes the function of a fuse.
This is where the MOV conducts again, and dissipated the energy.
the problem then depends on "how fast does the fuse operate?".
2024–10–10[John johnson John Johnson ]
2024–10–16 [ OO OLAOYE OYEBODE ]
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
eight
One
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
nine
[image of Common-mode choke]
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
First Sentence:
The bolt then partially travels down the line to your home.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
In schematic diagrams this is the symbol for a fuse:
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
One is “what exactly is in a ‘surge protector’ ? ”
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
The other is “what does a “fuse” do?”
Here is a simplified AC power diagram.
For this case there are devices called Metal oxide varistors (MOV).
Can the fuse protect the electronic devices from lightning instead of a surge protector.
He then asserts :
This is the picture of an electronic coil of wire wound around a core of magnetic material.
The MOV will conduct when the voltage exceeds 50% of line voltage.
An AC voltage/ current source, and an ac inductive load.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
A circuit breaker is similar, but is resettable.
I post the exact comment here.
what exactly is a ‘surge’ protector?
Now when you have a certain ac resistance, then a current flows in a loop.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Because the load is inductive, the current lags the voltage.(by a bit).
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Barnstars:
It seems Mohan does not understand the difference between a comment and an Answer.